Editing Recorded Tracks; Labeling/Relabeling Recordings - Sony Walkman MZ-S1 Mode D'emploi

Editing recorded tracks

You can edit your recordings by adding/
erasing track marks or labeling tracks and
MDs. Premastered MDs cannot be edited.
• You cannot edit tracks on an MD that is
record-protected. Before editing tracks, close
the tab on the side of the MD (page 52).
• If you perform an editing operation while
playing, be sure not to turn the power off until
"Edit" disappears in the display.
• Do not move the recorder while "Edit"* is
flashing in the display.
• The lid will not open until "Edit" disappears
in the display after editing.
• When group mode is on, editing can be
performed only for the tracks registered into
the selected group.
Labeling/relabeling
recordings
You can name tracks, groups and discs
using the recorder's character palette.
Available characters
• Capital and small letters of the English
alphabet
• Numbers 0 to 9
• ! " # $ % & ( ) * . ; < = > ?
@ _ ` + – ' , / : _ (space)
Numbers of characters you
can input
Track, group, or disc name: Approx. 200
each
Numbers of characters you
can input in a disc
Numbers/marks: Approx. 1,700
Notes
• "FULL" appears when you try to enter more
than 1,700 characters on a disc. Enter a shorter
name for the track, group, or disc, or set the
"LPStmp" setting to "OFF" when recording in
MDLP mode so that "LP:" is not be added at
the beginning of the track name (page 28).
• When labeling a disc which has been recorded
using the group function, make sure group
mode is on in order to prevent the group
management information from being
overwritten by mistake.
• If you enter the symbol "//" between the
characters in disc names such as "abc//def",
you may be unable to use the group function.
END SEARCH
Control key
VOL +/–
(./>/x)
X
GROUP/
CANCEL
MENU/ENTER
39
-GB