Sony Walkman MZ-S1 Mode D'emploi page 58

Symptom
An MD is not played
from the first track.
Playback sound
skips.
Sound has a lot of
static.
Cannot find the track
marks.
The disc cannot edit
on other component.
Momentary noise is
heard.
The display window
is not normal.
58
-GB
Cause/Solution
• Disc playing stopped before it came to the last track.
, Press N for 2 seconds or more to start playing.
• Group mode is turned on.
, Turn group mode off and play from the first track (press N
for 2 seconds or more to start playing).
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a track under one second long.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong
magnetism.
• You pressed X after pressing . or >.
, Press X before pressing . or >.
• The component does not support LP2 stereo or LP4 stereo.
, Edit on other component that support LP2 stereo or LP4
stereo.
• Due to the special digital audio compression technology used in
LP4 stereo mode, momentary noise may occur on very rare
occasions with certain sound sources.
, Record in normal stereo or LP2 stereo mode.
• The recorder was disconnected from the power source.
, Let the recorder sit for a while, or disconnect the power
source, reconnect it, and then press any of the operation
buttons.