Technical Information - Eurosystems M250 EVO Mode D'emploi

MAINTENANCE OF THE CUTTER BAR
most stress. It is abvious, therefore, that it must be particularly carefully serviced and correctly adjusted. It is advisable to clean the cutting mechanism
after each use. To do this the cutting edge must be removed so that the dirt which has collected between the blades and cutting bars can be completely
removed. Should the cutter bar not be in use for a longer period of time it should be sprayed with an anticorrosive agent. Although all types of bar cutting
mechanism are by and large resistant to the interference of stones and similar objects, it can occasionally happen that the bars and blades become damaged
or bent. It is necessary, therefore, to check the condition of these parts each time you sharpen the cutting blade after 4-6 hours of mowing depending on the
work load. Any damage must be made good and bent gars or blades repaired. Only well aligned bars and blades can guarantee a clean cut. At this point the
track directions of the cutting edges should also be chekked and too much play in the direction be removed by means of adjustment. Important - in order to
obtain a good supports setup, check the first one and then the other. After every regulation of each single support it would be better to verify how the blade
plays moving the same by hand.
CUTTING BLADE SHARPENING (Fig. 11)
the cutting blade is removed from the bar and carefully cleaned. It is necessary to check if both backs and edges of the blades are bent then you can go on with
the sharpening. Suitable to this purpose is a hand grinder with 15000 - 20000 revolutions per minute in conjunction with a cup-shaped grinding point with a 25
mm. diameter and 35 mm. lenght. Cutting bar blades need a cutting angle of 35°-40°.
CUTTING KNIFE CHANGE (Fig. 12)
into hole (2). We recommend changing the knife after 2 or 3 sharpenings. The bottom knife should be changed after the cutting knife should be changed after
a couple of changes of the upper one. In the meantime you have to change the plastic knife guides (3).
DESCRIPTIONS (Fig. 13)
bar - 6) Lever for the regulation of the side handlebar.

TECHNICAL INFORMATION

kg. ENGINE: air blast cooling. For further technical details and for the engine, please see the enclosed manual and instructions.
NOISE AND VIBRATION LEVEL
to document N 67 and ISO 5349. Level detected = 7,8 m/s
12
The cutting mechanism is one of those pieces of agricultural equipment, which is placed under the
When the cutting blade are blunt (this depends on work load) it must be reground. To perform so
To remove the top knife to change and sharpen it, remove screws (1) and pull the knife out with a pin push
1) Accelerator operating lever - 2) Drive operating lever - 3) Cutting bar clutching control lever - 4) Engine - 5) Cutting
Track: 430 mm - Cutting bar lenght: 870 mm - Total lenght: 1500 mm - Height: 1000 mm - Tyres: 2 4.00-6 - Mass: 60
Noise level when working in compliance with document N 67 L A e q = 91,4 dB (A). Handlebar vibration according
2 .