Tank Filling; Unpacking/Assembly; Technical Features; Start-Up And Shut-Down - Eurosystems MZP13 Manuel D'utilisation

Forward drive label.
Reverse drive label.
CAUTION – Read the manual.
CAUTION – Moving parts.

4. TECHNICAL FEATURES

GROSS and NET
CE declaration label
weight
on the last page
Rated power
Width 536 mm
Length 1300 mm
Height
990-1250 mm
Work width 46 cm
Diameter work
32 cm
tools
Max tool rotation
120 (RPM)
speed (RPM)
Package dimen-
80x53x71
sions
Sound power
CE declaration label
Acoustic pressure
on the last page
Vibrations
5. HANDLING AND PACKAGING
2 or more people are required to handle
packaging, using the handles on the card-
board box. The GROSS weight is indicated
in the "TECHNICAL FEATURES" chapter.
CAUTION!
Do not overturn or roll the machine. Pos-
sible damage to bonnets and mechanical
parts.
INFORMATION!
If more than one machine or interchange-
able equipment is supplied on pallets,
unload without dropping them on the
ground. Use a forklift if necessary.

6. UNPACKING/ASSEMBLY

1. 4 1. 4
1. 1 1. 1 1. 2 1. 2 1. 3 1. 3
1. 6 1. 6 1. 7 1. 7 1. 8 1. 8
CAUTION!
The motor is supplied without lubricating
oil. For information on the type of oil and
quantities to be used, refer to the motor
manual contained in the accessory bag
[D] 1. 1 1. 1 .
7. USE
CAUTION!
Add lubricating oil to the motor before
first start-up. For information on the type
of oil and quantities to be used, refer to
the motor manual contained in the ac-
cessory bag [D] .
1.1 1.1
CAUTION!
Before starting the machine, check the
oil level inside the motor, as indicated in
.
the specific user's manual
DANGER!
Before proceeding, read and understand
the chapter "SAFETY INSTRUCTIONS"
in its entirety.
DANGER!
Check correct functioning of the levers
before using the machine. See the "CA-
BLE ADJUSTMENT" paragraph to make
adjustments.
7.1 DESCRIPTION OF ELEMENTS
2. 1 2. 1
a. Throttle lever
b. Forward control lever
c. Reverse control lever
d. Spur
e. Blade (work tool)
f. Handlebar knob for handlebar tighten-
ing/adjustment
g. Handlebar
h. Transport wheel
i. Tools shield
l. Recoil starter grip
m. Motor

7.2 TANK FILLING

DANGER!
Use caution when handling flammable
fluids. Fuel is highly flammable and ex-
1. 5 1. 5
plosive.
DANGER!
Do not fill the tank in closed or poorly
ventilated environments.
DANGER!
Before refilling the tank, switch off the
machine and wait until the motor has
cooled down (15-20 min).
DANGER!
Do not smoke or use electronic devices
near combustible fluids.
DANGER!
Use suitable, undamaged filling devices
such as fuel cans, funnels, etc.
DANGER!
In case of fuel leakage, move the ma-
chine before starting it up.
DANGER!
When filling operations have been com-
pleted, replace the cap and tighten it
firmly.
2. 5 2. 5

7.3 START-UP AND SHUT-DOWN

DANGER!
Check correct functioning of the main-
tained action levers and double safety
command before using the machine. See
the "CABLE ADJUSTMENT" paragraph
to make adjustments. It is forbidden to
use the machine in case of malfunction
of the controls.