Problems And Solutions - Villager V 722 Mode D'emploi

Villager

6 PROBLEMS AND SOLUTIONS

6.1. THE MOWER IS MOVING TO THE LEFT OR RIGHT
Check the tire pressure, 30 PSI (210 kPa).
6.2. THE MOWER MOWS UNEVENLY
 Check the tire pressure, 30 PSI (210 kPa).
 Check the alignment of the housing.
 Check the blade tilt to tilt them in order to achieve evenness.
NOTE: The front of the mower housing will be about 1/8" to 1/4" (3mm - 6mm)
lower than the back of the housing. This is called the "tilt" of the housing.
6.3 THE ENGINE WILL NOT START
 Make sure that there is fuel in the fuel tank and that the fuel tank is open.
 Make sure the blade drive is off and the ignition switch is in the "ON" position.
 Check if the spark plug cord is properly connected.
 Check if the transmission is in neutral position.
 Check if there are loose or defective cables.
 Check for corrosion on all cable connections.
Even a small amount of corrosion can cause malfunction of the connection.
Thoroughly clean the connectors with the electrical contacts cleaner, apply
dielectric grease and reconnect.
NOTE: After carefully checking the above steps, try to start the engine. If it does
not start, contact an authorized workshop.
IMPORTANT: It is crucial that all the safety mechanisms of the operator be
connected and in working order - before the beginning of mowing.
If there is a problem, do not overlook the simple causes. For example, the problem
of starting may be caused by an empty fuel tank.
The following table contains some of the common causes of the problem.
26
V 722 (GB)