Villager V 722 Mode D'emploi page 55

Villager
 Start the engine and check for leakage. Stop the engine and check the oil level.
5.1.9 Check the pressure:
Service interval: 40 hours.
Stop the engine, wait for all moving parts to stop and remove the key:
 Inspect the tire pressure of the drive wheels.
 Pump the drive wheel tires to 30ps (210kPa).
 Inspect tire pressure in the castors.
 Pump the castor tires up to 30 psi (210 kPa).
5.1.10 Check the condition of the belts:
Service interval 40 hours.
 Stop the engine, wait for all moving parts to stop and remove the key.
 Inspect all belts.
 Remove the left and right belt buckles on the housing and place them on the
side to inspect the belts.
 See sections 5.2.2, 5.2.2.1 and 5.2.3 for adjusting belts.
5.1.11 Lubricate the lubrication connections
Service interval: See in the table.
 Stop the engine, wait for all moving parts to stop and remove the key. (See
Figure 7).
LOCATION OF
CONNECTOR
Lubrication diagram
NUMBER OF
THE CONNECTORS
1
2
Service interval:
1 50 hours
1 50 hours
24
V 722 (GB)