Important; Driving Operation; Stopping The Engine - Villager V 722 Mode D'emploi

Villager
key, pull the cable with interruptions - to start the engine. 3) For electric start,
turn the key switch to the "Start" position to start the engine.
 If the engine is cold, set the gas in the middle - between the "SLOW" and "FAST"
position and push the lever forward into the "ON" position. Turn the ignition
key to the "start" position. Release the key - as soon as the engine starts.
4.3 Mowing operation
Push the blade drive lever forward - to turn the blades on. Push the blade drive
lever backward - to turn the blades off. Make sure that all persons are away from
the mower housing and the discharge space - before turning on the PTO.
IMPORTANT: Set the accelerator to the "central" position. Push the blade drive
lever into the "ROTATE" position. Accelerate, start mowing.
 Stopping the blades: Place the accelerator in the "central" position, pull the
blade drive lever back to the "off" position - to stop the blades.
POTENTIAL HAZARD
- An uncovered drain hole will allow objects to be thrown off in the direction of
the operator or observer. Also, contact with the blade can occur.
WHAT COULD HAPPEN
- Thrown off objects or contact with the blade can lead to severe injury or even
death!
HOW TO AVOID DANGER
-
Never work with a mower with lifted, removed, or pre-set discharge cover,
unless the grass collecting system or mulching kit is in proper place and
operating properly.

4.4. Driving operation

Squeeze the left and right handgrip of the control levers and move the neutral lock
in the locked position. Release the handles and select the speed - by moving the
gear shift lever from the neutral position to the desired speed.
Squeeze the left and right control lever, release the locks, and then slowly release
the control levers - to move forward. To turn right, squeeze the right control lever,
and to turn left - squeeze the left control lever.

4.5 Stopping the engine

Pull the blade drive lever back into the off position – to stop the blades. Squeeze
the left and right handgrip of the control levers and move the neutral locks in the
DANGER
19
V 722 (GB)