Safety Labels - Villager V 722 Mode D'emploi

Villager V 722 (GB)
1.5.5 Equipment running on gasoline or fuel canisters - should not be stored in
basements or in an enclosed room - where open pilot flames or heaters are
located.
1.5.6 Maximum mowing performance and safety - can be achieved only if the
mower is properly maintained and properly handled.
1.5.7. Often inspect all screws - to maintain the prescribed tension.
1.5.8 Keep all shields, bumps and safety devices in place and in a safe working
condition.
1.5.9 Often check for any worn or damaged components - which may pose a risk.
1.5.10. All spare parts must be identical or equivalent to parts - delivered on the
original equipment.

1.6 SAFETY LABELS

1.6.1 Keep all security (safety) labels in a readable state. Remove all grease, dirt,
and waste from the safety labels and instruction labels.
1.6.2 Safety labels have to be replaced - if they are missing or illegible.
1.6.3 When new components are installed - ensure that valid safety labels are stuck
to new components.
1.6.4 New labels should be purchased at an authorized service workshop.
1.6.5 Safety labels must be adhered by removing (unsticking) the rear layer (base) -
to reveal the adhesive surface. Only apply on a clean, dry surface. Flatten – to
remove all bubbles.
1.6.6 Familiarize with the following safety labels and instruction labels. They are
critical to the safe operation of your device.
9