Setting Up For Installation - Dalla Corte evo2 Notice Pour L'utilisateur

Setting up for installation

The machine shall be placed on a surface guaran-
teeing secure support.
When arranging the systems, a hole (10 x 10 cm
A Pic. 1 shall be made in the support surface to
allow the connections with the systems in the un-
der counter space
The machine must be connected exclusively to an
appropriate cold drinking water source, in compli-
ance with national norms and rules.
The pressure of the incoming water must be bet-
ween 0.1 and 0.6 MPa. If this requirement is not
met, consult the manufacturer.
38
B Pic. 1.
A shut-off tap must be installed between machine
water hose and water system to block water flow
1
in case of necessity (
Connect the drain siphon
diameter of 40 mm to the drain system of the place
of installation.
The machine has no plug since it requires a direct
connection to the electrical network. It is thus ne-
cessary to install an omnipolar switch compliant
with norms and rules (
Pic. 1).
5
Pic. 1 with a minimum
7
Pic. 1).