Accessories; Assembling The Support Rod; Maintenance - IKA C-MAG HS 4 digital Mode D'emploi

Accessories

Stirring organs
stirring bars: Ø 6 mm, length to 15 mm
Ø 8 mm, length to 50 mm
Ø10 mm, length to 80 mm
Any other accessories
RSE stirring bar remover
RS1 stirring bar set
H15 bath top
H28 bath top
H16V support rod
H38 holding rod
H44 cross sleeve

Assembling the support rod

The support rod is attached using the threaded support bore (H).
• Screw nut M10 on to the support rod as far as the stop
• Screw on the support rod as far as the stop by hand
• Tighten the support rod and nut M10 using a flat wrench
(SW17).
• Use bossheads to assemble accessory parts or
accessory devices.
The appliance is maintenance-free.
Cleaning
Only use cleansing agents which have been recommended by IKA
Use to remove:
Dyes
Construction materials
Cosmetics
Foodstuffs
Fuels
- Do not allow moisture to get into the appliance when cleaning
- Wear protective gloves during cleaning the devices.
- Before using another than the recommended method for clean-
ing or decontamination, the user must ascertain with IKA
this method does not destroy the instrument.
Ordering spare parts
When ordering spare parts, please give:
- Machine type
- Manufacturing number, see type plate
- Item number and designation of the spare part, see www.ika.com
Repair
H
Please only send devices in for repair that have been cleaned and are free
of materials which might present health hazards.
For this, use the "certificate of compliance" form which you can
obtain from IKA
website at www.ika.com.
If your appliance requires repair, return it in its original packaging.
Storage packaging is not sufficient when sending the device - also use
appropriate transport packaging.

Maintenance

isopropyl alcohol
water containing tenside/ isopropyl alcohol
water containing tenside/ isopropyl alcohol
water containing tenside
water containing tenside
® or can download a version for printing from the IKA
® .
® that
®
15