Using The Coupling Extractor; Maintenance And Cleaning; Accessories - IKA Tube Mill control Mode D'emploi

Milling tube coupling broken:
The milling tube coupling may be broken when the
grinding material is too much or too hard.
Pull the broken coupling out from the drive unit:
 Fit the coupling extractor in clockwise direction. The
coupling puller is properly attached to the coupling af-
ter a "click".
 Turn the coupling extractor in counterclockwise direction.
The broken coupling will be extracted out after a "click".
The instrument is maintenance-free. It is only subject to
the natural wear and tear of components and their statisti-
cal failure rate.
Cleaning:
Disconnect mains plug prior to
cleaning!
- Wear protective gloves when cleaning the devices.
- Do not place electrical appliances into the cleaning
agents for cleaning purposes.
- Do not allow moisture to get into the appliance when
cleaning.
- Please consult IKA before using any cleaning or decon-
®
tamination methods, other than those recommended
here.
- The device must not be washed in a dishwasher.
- The protective hood is of polycarbonate and can be treat-
ed using commercially-available disinfectants. Avoid prod-
ucts that contain aldehydes, phenols, acetone or alcohol.
- It should be cleaned only by hand using a liquid disin-
fectant.
- The only cleaners or disinfectants that may be used are
those that:
- lie in the pH range 5 - 8,
- contain no corrosive alkalis, peroxides, chlorine
compounds, acids or brine.
- If rotator becomes contaminated with milled material,
clean it thoroughly with vacuum cleaner.
• MT 40 Milling tube
• MMT 40.1 Multi-use milling tube package

Using the coupling extractor

Maintenance and cleaning

Only clean IKA
cleaning agents. To remove use:
Dirt
Dyes
Building materials
Cosmetics
Food
Fuels
Other materials
Spare parts order:
When ordering spare parts, please give:
- Machine type.
- Serial number, see type plate.
- Item and designation of the spare part,
- software version.
Repair:
Please send instrument for repair only after it has
been cleaned and is free from any materials which
may constitute a health hazard.
For this you should request the "Decontamination Cer-
tificate" from IKA
from the IKA
Return the instrument in its original packaging. Storage
packaging is not sufficient. Also, please use suitable ship-
ping package material.

Accessories

• A-MMT 40.100
• Labworldsoft
I
II
CLICK

appliances using these IKA
®
Cleaning agent
isopropyl alcohol
(do not use for the protective hood)
water containing detergent, Isopropanol
(do not use for the protective hood)
Water containing detergent, Isopropa-
nol (do not use for the protective hood)
Water containing detergent
Water containing detergent
Please consult IKA
see www.ika.com, spare parts diagram and spare parts list.
, or use the download printout of it
®
website www.ika.com.
®
®
III
CLICK
approved
®
®
Abrasion set

21