Commissioning; Switching On The Instrument - IKA Tube Mill control Mode D'emploi

OUT_SP_X m
X=4
START_X
X=4
IN_SOFTWARE
Pay attention to the ambient conditions listed in the
"Technical Data".
Check whether the voltage given on the type plate cor-
responds to the available mains voltage.
The socket used must be earthed
(fitted with earth contact)
If these conditions are met, the unit is ready for operating
when the mains plug has been plugged in.
If these conditions are not met, safe operation is not guar-
anteed and the machine can be damaged.
Attach the milling tube by twisting it clockwise on to the
bayonet coupling of the drive. The tube is correctly at-
tached after a "click". Then close the protective hood.
If above procedures are not followed, the tube mill will not
start.
Note: remove the milling tube by twisting it counterclock-
wise. After a "click", the milling tube can be removed from
the bayonet coupling.
 Switch on the instrument with mains switch (A).
 The device enter the standby status.
Standby
 Press the power key (D).
 The start-up screen will be displayed for several sec-
onds. This screen shows the unit designation and the
software version.
 Then, the system check screen will be displayed for few
seconds.
Set target speed value, input: rpm
Switch on appliance remote function.
Start value function with setting.
Request software ID, number, date and version

Commissioning

Switching on the instrument

CLICK
Symbols are shown on the screen, including the working
mode setting, the target speed, the maximum rotation
speed (rpm) and timer maximum value etc. of the instru-
ment.
Symbols Explanation:
 Maximum speed value
 Rotation symbol
 Rotation speed setting
 Operation mode
 "Timer" maximum value of the device
 "Timer" symbol






17