Safety Instructions - IKA C-MAG HS 4 digital Mode D'emploi

Contents
Declaration of conformity
Safety instructions
Unpack
Correct use
Setting operating modes
Safe temperature limit
Setting HI TEMP
Warranty
Commissioning
Error codes
Accessories
Assembling the support rod
Maintenance
Technical data

Safety instructions

To your protection
• Read the operating instructions in full before starting up
and follow the safety instructions.
• Keep the operating instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health and
safety and accident prevention regulations.
• Socket must be earthed (protective ground contact).
• Attention-Magnetism! Effects of the magnetic field have to be
taken into account (e.g. data cardiac, carriers pacemakers...).
• Risk of burns! Exercise caution when touching the housing parts and
the heating plate. The heating plate can reach temperatures in excess
of 500 °C. Pay attention to the residual heat after switching off.
• Please make sure that the mains cable does not contact the hea-
ting plate.
• Wear your personal protective equipment in accordance with the
EN
hazard category of the medium to be processed. Otherwise there
is a risk of:
Page
- splashing liquids
4
- projectile parts
11
- release any toxic or combustible gases.
12
• Set up the appliance in a spacious area on an even, stable, clean,
12
non-slip, dry and fireproof surface.
13
• The feet of the appliance must be clean and undamaged.
13
• Position the knob at the left stop before starting up. Gradually
13
increase the speed.
13
• Reduce the speed if
14
- the medium splashes out of the vessel because the speed is too
14
high
15
- the appliance is not running smoothly
15
- the container moves on the set-up surface.
15
• Caution! Only process and heat up any media that has a flash point
16
higher than the adjusted target temperature (0 to 500 °C) that has
been set.
The target temperature must always be set to at least 25 °C lower
than the fire point of the media used.
• Check the appliance and accessories beforehand for damage each
time you use them. Do not use damaged components.
• Only replace damaged parts with spare parts identical to the origi-
nal in function and quality.
• Do not use the device if the ceramic set-up surface is damaged,
e.g. scratches, splinters or corrosion. A damaged set-up surface
could break if used.
• Beware of the risk of
- flammable materials
- glass breakage
- incorrect container size
- too much medium
- unsafe condition of container
• Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any extra
energy produced in other ways, e.g. through light irradiation.
• Process pathogenic materials only in closed vessels under a suitable
11