Unpack; Correct Use - IKA C-MAG HS 4 digital Mode D'emploi

extractor hood. Please contact IKA
• Do not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
• Please observe the operating instructions for any accessories used.
• The socket for the mains cord must be easily accessible.
• Ensure that the external temperature sensor PT 1000 is inserted in
the media to a depth of at least 20 mm.
• The external temperature sensor PT 1000 must always be inserted
in the media when connected.
• The appliance can only be disconnected from the mains supply by
pulling out the mains plug or the connector plug.
• Safe operation is only guaranteed with the accessories described
in the "Accessories" chapter.
• Always disconnect the plug before fitting accessories.
• Accessories must be securely attached to the device and cannot
come off by themselves. The center of gravity of the assembly
must lie within the set-up surface.
• The appliance starts up again automatically following a cut in the
power supply (in operating mode B / C).
• The appliance may heat up when in use.
• Abrasion of the dispersion equipment or the rotating accessories
can get into the medium you are working on.
• When using PTFE-coated magnetic bars, the following has to be
noted: Chemical reactions of PTFE occur in contact with molten or
dissolved alkaline and alkaline - earth metals, as well as with fine-
particled powders of metals of the 2. and 3. group of the periodi-
cal system at temperatures above 300-400 °C. Only elementary
fluorine, chlorine trifluoride und alkaline metals do attack PTFE,
halogen hydrocarbons have a reversibly swelling effect.
Source: Römpps Chemie-Lexikon and "Ullmann" Bd.19
To the protection of the equipment
• The appliance may only be opened by experts.
• The voltage stated on the nameplate must correspond to the
mains voltage.
• Do not cover the device, even partially e.g. with metallic plates or
film. This results in overheating.
• Protect the appliance and accessories from bumps and impacts.
• Ensure that the base plate is kept clean.
• Observe the minimum distances between devices, between the
device and the wall and above the assembly (min. 800 mm).
12
®
if you have any questions.

• Unpack

• Delivery scope
• Use
• Range of use
This device is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply network that
also supplies residential areas.
The safety of the user cannot be guaranteed if the appliance is ope-
rated with accessories that are not supplied or recommended by the
manufacturer or if the appliance is operated improperly contrary to the
manufacturer's specifications.
Unpack
- Please unpack the device carefully
- In the case of any damage a fact report must be set
immediately (post, rail or forwarder)
- Heating magnetic stirrer - PT 1000
- Mains cable - Operating instructions

Correct use

-
For mixing and/or heating liquids
- Laboratories - Schools - Pharmacies