Unpack; Correct Use - IKA C-MAG HS4 Mode D'emploi

- unsafe condition of container
• Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any
extra energy produced in other ways, e.g. through light irradiation.
• Do not operate the appliance in explosive atmospheres, with
hazardous substances or under water.
• A seperation from the line is made with the equipment only by
pulling net and/or device plug.
• Safe operation is only guaranteed with the accessories described
in the "Accessories" chapter.
• Always disconnect the plug before fitting accessories.
• Accessories must be securely attached to the device and cannot
come off by themselves. The centre of gravity of the assembly
must lie within the the set-up surface.
• The appliance starts up again automatically following a cut in the
power supply.
• The appliance may heat up when in use.
• Abrasion of the dispersion equipment or the rotating accessories
can get into the medium you are working on.
To the protection of the equipment•
on the nameplate must correspond to the
mains voltage.
• Do not coer the device, even partially e.g. with metallic plates or
film. This results in overheating.
• Protect the appliance and accessories from bumps and impacts.
>100 mm >100 mm
4
• Observe the minimum distances between devices, between the
device and the wall and above the assembly (min. 800mm)

Unpack

• Unpack
- Please unpack the device carefully
- In the case of any damage a fact report must be set
• Delivery scope
- Heating magnetic stirrer
- Mains cable
The voltage stated
- Operating instructions

Correct use

• Use
-
• Range of use
- Laboratories
- Chemical industry
>100 mm
immediately (post, rail or forwarder)
or
Magnetic stirrer or
Heating device
For mixing and/or heating liquids
- Schools
- Pharmacies
CMAG 032006