Panasonic REAL PRO Elite EP3513 Mode D'emploi page 17

3. Adjust massage position and strength.
(These adjustments cannot be made with the controller cover closed.)
Adjusting Massage Position
• The approximate position of the massage will be shown on the Massage Area Display.
position
• If you hold the up or down button down the massage heads will continue to move until you release
the button.
Press .
• In some places the strength of the massage will be automatically reduced. (See Page 33)
• In some cases the massage position will not immediately change even though the Roller Position
button is pressed.
Adjusting Massage Strength
• The strength of the massage is shown on the Upper Body Massage Action Display in five stages.
intensity
• In some cases the degree to which the strength of the massage can be adjusted will depend on
the area being massaged. (See Page 33)
Press .
• In some cases the massage strength will not immediately change even though the Massage
Strength button is pressed.
• The strength of the back vibration function is not adjustable.
Adjusting Massage Speed
speed • The speed of the massage is shown on the Upper Body Massage Display in five stages.
• The speed of the back vibration function is not adjustable.
Press .
Adjusting Lateral Movement
• Press this button to increase the width of the massage in the location the massage
lateral
heads were in when you pressed the button.
• will be shown on the display.
• In some places the strength of the massage will be automatically reduced.
Press .
(See Page 33)
• Back vibration cannot be combined.
• Press the button again to revert to normal massage action.
Combining with the Back Vibration
vibration
Press .
(Press again to turn off.)
4. When the massage is finished the unit will automatically shut off.
(The massage will finish approximately 15 minutes after it starts.)
• The massage heads will retract and then stop.
30
All manuals and user guides at all-guides.com
The display will indicate whether the back
vibration function is turned on or off.
(Lit areas indicate active functions. Unlit
areas indicate inactive functions.)
USING MANUAL OPERATION (Lower Body)
Manual Operation for Massage of the Lower Body
2
leg stretch vibration
Leg Stretch OFF/ON button
3. Adjust to your preferred level of strength.
intensity
Press .
Back
Vibration
Combining with the Leg Stretch Function
leg stretch
Press .
(Press again to turn off.)
4. When the massage is finished the unit will automatically shut off.
(The massage will finish approximately 15 minutes after it starts.)
• It will take a number of seconds for the air to be completely released. (After pressing
being released.)
• Press if you want to stop the massage during a program. Press
immediately. (See Page 18)
1. Press to turn on the power.
A B A B
knead knead
2. Select your massage action of preference.
intensity intensity Pressed One Time
Knead A + Knead B
A B
knead
hands/ lower
arms body
Massage Strength button
Control
Display
• The selected massage action may be changed to another
part way through the massage. If this is done the massage
will start again once the air has been released.
• Only the legrest will automatically
rise to the correct massage
position.
• The strength of the massage is shown on the Lower Body Massage Display in five stages.
• The massage strength can be adjusted until a "beep-beep-beep" sound is heard.
• The strength of the leg stretch and back vibration functions is not adjustable.
The display will indicate whether the leg stretch
function is turned on or off.
(Lit areas indicate active functions. Unlit areas
indicate inactive functions.)
Pressed Two Times Pressed Three Times
Knead A Knead B
A B A B
knead knead
Raised
approximately 55°.
Leg
Stretch
you will hear air
if you want to stop the massage
31