Scheppach OX 3-1000 Traduction Du Manuel D'origine page 14

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
For faults not mentioned here, please contact the customer service of the company scheppach.
Fault
The hydraulic pump is not
running.
The beam is not moving
downwards.
Motor runs, but beam is not
moving downwards.
maintenance and Repairs
All maintenance work has to be carried out by qualified personnel in strict adherence to the operating manual in hand.
Before each maintenance procedure, you must take all possible precautions, switch off the motor, and disconnect the power
supply (pull the power plug if necessary). Attach a sign to the machine explaining the breakdown situation: "Machine out
of order because of maintenance: Unauthorised persons are forbidden to stay near the machine or to operate it."
14 english
OX 3-1000 2011.indd 14
troubleshooting
possible Causes
Remedy
No power
Check if there is voltage on
the wires.
The thermal circuit breaker
The thermal circuit breaker
of the motor tripped.
will switch back on after
the motor cooled down. The
motor can be restarted.
Low oil level
Check oil level and
replenish.
Two hand control out of
Check attachment of the
order
levers.
Dirt in the beam guides
Clean beam.
Wrong direction of rotation
Check direction of rotation
of the three-phase motor
of the motor and reverse.
Level of Danger
Electrical hazard
This work step must be
carried out by a service
electrician.
Danger of contamination!
This work step may be
carried out by the machine
operator.
Cutting hazard!
Wrong direction of rotation
may damage the pump.
Falsche Drehrichtung kann
die Pumpe beschädigen
07.11.11 12:03

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1604 0938

Table des Matières