Additional Safety Rules - Panasonic EY6950 Instructions D'utilisation

Read "the Safety Instructions" booklet
and the following before using.
. ADDITIONAL
SAFETY RULES
1) Be aware that this tool is always in an
operating condition, since it does not have
to be plugged into an electrical outlet.
2) When drilling or driving into walls, floors,
etc., "live" electrical wires may be encoun-
tered. DO NOT TOUCH THE CHUCK
OR ANY FRONT METAL PARTS OF
THE TOOL! Hold the tool only by the
plastic handle to prevent electric shock in
case you drill or drive into a "live" wire.
3) If the bit becomes jammed, immediately
turn the main switch off to prevent an over-
load, which can damage the battery pack
or motor.
Use reverse motion to loosen jammed bits.
4) Do NOT operate the Forward/Reverse
lever when the main switch is on. The
battery will discharge rapidly and damage
to the unit may occur.
5) During charging, the charger may be-
come slightly warm. This is normal. Do
NOT charge the battery for a long period.
6) Use only a dry, soft cloth to wipe the unit.
Do NOT use a damp cloth, thinner, ben-
zine, or other volatile solvents for cleaning.
7) When storing or carrying the tool, set the
Forward/Reverse lever to the center posi-
tion (switch lock).
8) Do not strain the tool by holding the
speed control trigger halfway (speed con-
trol mode) so that the motor stops.
9) Wear ear protectors when using the tool
for extended periods.
10) Young children should be supervised to en-
sure that they do not play with appliance.
. ASSEMBLY
Attaching or removing bit
NOTE:
When attaching or removing a bit,
disconnect battery pack from tool
or place the switch in the center
position (switch lock).
This tool is equipped with a keyless
drill chuck.
1. Attachment
Insert the bit and turn the Lock collar
clockwise (looking from the front) to
tighten firmly until it stops clicking.
2. Removal
Turn the Lock collar counterclock-
wise (looking from the front), then
remove the bit.
3. Storage
Keep the bit in bit holder when not in
use.
R e m o v e t h e b a t t e r y p a c k t o
expose the bit storage compart-
ment inside the handle housing.
Bits up to 50
mm (1-31/32
inch) long can
be stored here.
NOTE:
If excessive play occurs in the
chuck, secure the drill in place
and tighten the chuck by turning
clockwise,
by unscrewing the Lock collar and
tighten the screw (left-handed
screw) with a screwdriver by turn-
ing it counterclockwise (viewed
from the front).
- 4 -
Lock collar
Lock collar
open the chuck jaws