Abus HomeTec Pro CFT3000 Mode D'emploi page 22

c. MENU ADMIN CODE
It is essential to change the admin code on initial commissioning or factory reset!
Enter previous code:
Enter new code:
Re-enter code:
Successful change is displayed. In case of an error message, rectify the relevant error.
confirm, to return to the main menu.
Note: the admin code is used only to configure the keypad. To operate it is necessary to create
a user (MENU e).
d. MENU TEACH IN
Note: The drive must be in teach-in mode. See CFA, FCA / FSA instructions.
2, Door 3. Note: if you are using multiple drives on different doors, select the required drive
and send the login code from the keypad to the drive.
confirmation OK?
cancel
e. MENU USER
User 1, User 2, ... User 32.
User active,
Note: to create a new user, select the user marked with
Name: User
Alphabet/Numbers
A B
D E
1.
G H
A/a
PRESS
22
-
0 9
- (Note: 5-10 digits.)
0 9
-
0 9
Again
confirm
User not active,
The assignment of the characters to the numeric fields on the keypad
will appear.
C J
F M
2.
I P
1
4
4.
7
User not applied
K L
N O
3.
Q R
A/a
2 3
5 6
8 9
0
Sending login code. Door drive
and confirm with
S T U
V W X
Y Z _
A/a
Door 1, Door