Description Of Symbols; Standard Equipment; Assembly And Disassembly Of The; Ass - Viking ASS 125 Manuel D'utilisation

For this reason, only slopes with a slope
inclination that is significantly smaller than
10° can be driven on safely in winter,
particularly when clearing snow.

4. Description of symbols

Caution - danger of crushing!
Never put hands or feet on or underneath
moving parts.

5. Standard equipment

Item Designation
A Snow plough assembly
– Instruction manual
0478 907 9918 B - EN
6. Assembly and
disassembly of the ASS 125

6.1 Installing the cover

Note:
To prevent damage to the
discharge chute when the mowing
deck is not installed, it must be
removed on the models
MT 5097/ G/ C/ K/ Z, MT 5112 Z,
MT 6112 C/ ZL and MT
6127 ZL/ KL. When the discharge
chute is not installed, the cover
must be installed as a safety
device.
● MT 5097/ G/ C/ K/ Z, MT 5112 Z,
MT 6112 C/ ZL, MT 6127 ZL/ KL:
Remove the discharge chute.
(See instruction manual of the ride-on
2
mower)
Qty.
● MT 5097/ G/ C/ K/ Z:
1
Fit the cover (1) onto the screws (3)
1
using the respective inner bores (2).
Fasten the cover (1) by turning the
nuts (4).
● MT 5112 Z, MT 6112 C/ ZL,
MT 6127 ZL/ KL:
Fit the cover (1) onto the screws (3)
using the respective outer bores (5).
Fasten the cover (1) by turning the
nuts (4).

6.2 Installing the snow plough

Risk of injury!
The weight must be taken into
consideration before lifting the
snow plough (A). The weight of the
3
entire snow plough assembly is
36 kg.
For safety reasons, the snow
plough should only be lifted with the
help of a second person.
Always secure the attached snow
plough with the cotter pin.
● Stop the engine.
(See instruction manual of the ride-on
mower)
● Engage the parking brake.
(See instruction manual of the ride-on
mower)
● Remove the mowing deck (follow all of
the instructions in the instruction
manual of the ride-on mower precisely).
● Install the cover. (
● Lower the coupling triangle completely.
( 7.1)
● Swivel the coupling triangle to the
central position. (
Step 1:
● Open the clamp on the cotter pin (2).
Detach and remove the cotter pin (2).
Step 2:
● Lift snow plough assembly (A) and
lower it along both guides (3) (grey
surface) of the coupling triangle (1) from
above. Insert the centring pin (4)
through the bore in the snow plough.
Step 3:
4
6.1)
7.3)
25