Transport Position - Viking ASS 125 Manuel D'utilisation

● Grasp the lift arm (1) by the handle with
one hand, press it down and hold it.
Push the lift arm (1) outwards slightly
(away from the ride-on mower) and
slowly guide it upwards until the snow
plough is in full contact with the ground.
Release the lift arm (1).
10.4 Swivelling the snow plough
● Bring the ride-on mower to a complete
standstill.
(See instruction manual of the ride-on
mower)
● Raise the snow plough into the

transport position.

● Actuate and hold the swivel arm
release.
● Swivel the snow plough into the desired
position by actuating the swivel arm.
● Release the swivel arm release and
ensure that the locking mechanism of
the coupling triangle engages.
● Release the swivel arm.
10.5 Snowploughing
Risk of injury.
Clear snow at walking speed only,
never at maximum driving speed.
Prior to ploughing, check the area
to be cleared thoroughly and mark
or remove all protruding obstacles
(overhangs, pavement, flagstones,
etc.).
Approach large accumulations of
snow (e.g. already ploughed snow)
at low speed only.
0478 907 9918 B - EN
Note
Before ploughing, read and
observe the section "Notes on
working with the machine". (
Starting (hydrostatic gearbox):
Note
Please see the ride-on mower
instruction manual to determine
whether the mower is equipped
with a hydrostatic or manual
gearbox.
● Start the engine.
(See instruction manual of the ride-on
mower)
● If necessary, turn the light on.
(See instruction manual of the ride-on
mower)
● Put the snow plough in the transport
position. ( 10.2)
● Drive the ride-on mower onto the area
to be cleared.
(See instruction manual of the ride-on
mower)
● Set the throttle lever to the MAX
position. The throttle lever must always
be in the MAX position while clearing
snow.
(See instruction manual of the ride-on
mower)
● Swivel the snow plough into the desired
position. ( 7.3)
● Lower the snow plough to the working
position. ( 10.3)
● Press the drive pedal slowly and
carefully. The ride-on mower starts
moving slowly.
If necessary, increase the driving
speed.
(See instruction manual of the ride-on
mower)
Braking (hydrostatic gearbox):
● Release pressure on the drive pedal
until the mower comes to a standstill.
8.)
(See instruction manual of the ride-on
mower)
● Operate the brake as required.
(See instruction manual of the ride-on
mower)
● Put the snow plough in the transport
position if necessary. (
Starting (manual gearbox):
Note
Please see the ride-on mower
instruction manual to determine
whether the mower is equipped
with a hydrostatic or manual
gearbox.
● Start the engine.
(See instruction manual of the ride-on
mower)
● If necessary, turn the light on.
(See instruction manual of the ride-on
mower)
● Put the snow plough in the transport
position. ( 10.2)
● Drive the ride-on mower onto the area
to be cleared.
(See instruction manual of the ride-on
mower)
● Set the throttle lever to the MAX
position. The throttle lever must always
be in the MAX position while clearing
snow.
(See instruction manual of the ride-on
mower)
● Swivel the snow plough into the desired
position. ( 7.3)
● Lower the snow plough to the working
position. ( 10.3)
10.2)
29