eurodent ISOTRON Notice D'installation page 43

ISOTRON - ISOPLUS - ISOPLUS LITE - ISOCONCEPT
40
ISOTRON
If the dental unit is equipped with assistant syringe, follow the
steps below:
Insert the syringe hose into its housing on the tubings carrier,
and make it run upwards through the hole placed between the
suction filter and the tank for tubings cleaning. Then, lock the
end bush with the clip supplied.
Unscrew the screws which lock the lid of the box of the 6-
function syringe rod located on the suction cleaning tank and
connect the hoses and wires of the syringe hose. Finally, replace
the lid.
Now, insert the suction pipes into their housings on the tubing
carrier and connect the couplings to the proper fastening
bushes.
E9
ISOPLUS, ISOPLUS LITE
If the dental unit is equipped with assistant syringe, follow the
steps below:
Insert the syringe hose into its housing on the tubings carrier,
and make it run upwards through the hole placed between the
suction filter and the tank for tubings cleaning. Then, lock the
end bush with the clip supplied.
Unscrew the screws which lock the lid of the box of the 6-
function syringe rod located on the suction cleaning tank and
connect the hoses and wires of the syringe hose. Finally, replace
the lid.
Now, insert the suction pipes into their housings on the tubing
carrier and connect the couplings to the proper fastening
bushes.
E10
ISOCONCEPT
If the dental unit is equipped with assistant syringe, follow the
steps below:
Insert the syringe hose through the hole at the left side of the
suction filter. Then, lock the end bush with the clip supplied.
Connect the water hose to the corrisponding coupling placed
near the suction filter.
Connect the air hose to the air reduction unit for the syringe.
E11
Installation instructions