Important - eurodent ISOTRON Notice D'installation

Installation instructions
ISOTRON - ISOPLUS - ISOPLUS LITE - ISOCONCEPT
Now, install the instrument table arm of the dental unit (however
first make the cable and hoses run through the body) and block
the travel of the arm by inserting the screw and the nut (supplied
with accessories) into the pin hole.
ISOTRON, ISOPLUS, ISOPLUS LITE
Plug the arm cord into CN1 (on left top side), on the low-tension
rod. Then, connect the white hose to the quick fitting which
provides modules with air, placed on the right side of the air
reduction units. Moreover, connect the red hose (ISOTRON
only) to the fitting placed on the lid of the amalgam header, and
the green one to the water distribution unit (for tumbler,
assistant syringe and modules), placed on the chair side.
ISOCONCEPT
Plug the arm cord into X1 and X2 (on left top side), on the p.c.b.
Then, connect the white 3/5 hose to the union for permanent
air, placed on the right side of the air reduction unit. Moreover,
connect the green one to the water distribution unit. The other
pipes should be connected to the proper unions placed on the
E6
water unit.
IMPORTANT: When assembly, always respect the
correspondences of the pipe colours.
Fasten the tray holder under the module-holder table (to make
it easier, use a 17 socket spanner).
E7
Now, insert the cable and the pin of the assistant arm into the
proper housing (at the bottom of the body, on the chair side),
and lock the pin with the snap ring and its lock space washer.
Make the cable run through the body and plug it in the C5 socket
(for ISOTRON) or in the C2 (for ISOPLUS and ISOPLUS LITE),
placed on the low-tension p.c.b., or in the X5 socket of the body
p.c.b. (for ISOCONCEPT).
NOTE: ensure that the cable does not hang under the body).
Insert the friction unit into the hole beside the pin housing and
tighten the screw properly.
E8
39