C Installing The Iso Chair; Backrest; Backrest Upholstery - eurodent ISOTRON Notice D'installation

C - INSTALLING THE ISO CHAIR
Installation instructions
ISOTRON - ISOPLUS - ISOPLUS LITE - ISOCONCEPT

BACKREST

Remove the chair from the packing by cutting along the dash-
line, and lift the backrest until the hitch point matches the push
rod.
Carefully insert the shim in its housing, and after fitting the
screw in its housing, tighten it with the suitable wrench.
Now the chair can operate and some test movements should be
performed to ensure that stop microswitches operate properly.
C1
Then proceed by mounting upholstery.
C2

BACKREST UPHOLSTERY

Position upholstery slightly over the backrest and make it slip
down so that it fits in the two fastening screws.
When upholstery is properly positioned, fit the screw into the
suitable hole on the back side and tighten the M4 dowel by
using the 2 mm Allen wrench.
If the pad does not match properly with the backrest, adjust the
two flathead screws as described for the headrest pad.
C3
33