eurodent ISOTRON Notice D'installation page 40

E - INSTALLING THE ISOTRON, ISOPLUS, ISOPLUS LITE, ISOCONCEPT DENTAL UNITS
ISOTRON
ISOPLUS
ISOPLUS LITE
Net weight ...... 71
Gross weight ... 88
.......... 0,555 m
cm. 96 x 89 x 65
"INSTRUMENT TABLE"
Net weight ...... 22
Gross weight ... 33
.......... 0,428 m
cm. 88 x 76 x 64
Installation instructions
ISOTRON - ISOPLUS - ISOPLUS LITE - ISOCONCEPT
ISOCONCEPT
"BASE"
Net weight ...... 46
Gross weight ... 65
.......... 0,555 m
3
cm. 96 x 89 x 65
Net weight ...... 18
Gross weight ... 30
3 .......... 0,428 m
cm. 88 x 76 x 64
The dental unit is supplied into two packing cases: the first one
labelled "BASE" contains the body and the assistant arm; the
second one labelled "INSTRUMENT TABLE" contains the operator
3
retraction arm, the modules and the tray holder.
Provide air and water hose couplings with taps. It is absolutely
necessary to clean out air and water pipes before connecting
the dental unit to them.
3
E0
In addition to the guard of the connecting box, we recommend
that you remove even the lid of the chair parallelogram, in order
to operate easily when introducing hoses and cables into the
dental unit. Remove such mentioned lid by unscrewing the two
long brass nuts which are placed under it and which fasten it to
the upper rods of the parallelogram.
The chair shall be fastened to floor by inserting expansion bolts
into the two holes made on the front side of the base footboard.
E1
Now, mount the body of the dental unit on the chair support by
means of the stud bolts and the socket head screws supplied
(placed inside the "ACCESSORY" box, into the packing case
labelled "BASE").
ISOTRON, ISOPLUS, ISOPLUS LITE
Before fastening screws and nuts, level the body properly
horizontally and vertically. Please, note that stud bolts shall be
inserted into the support lower holes, whereas screws into the
higher ones.
ISOCONCEPT
To make such operation easier, fit the additional Allen-head
stud bolt supplied into the second of the two lower holes.
Level the body properly (horizontally and vertically) before
tightening the two screws and the middle nut; remove the Allen-
head stud bolt from the lower hole and replace it with the third
E2 screw supplied.
37