Service And Customer Care - Kenwood AT640 Mode D'emploi

8 Switch on and push down evenly
with the pusher - never put your
fingers in the feed tube. For
most operations use speed 1 or 2. If
more power is required increase to
speed 3.
At the completion of the processing
G
operation, raising and lowering the
pusher several times may help to
reduce the amount of food left on
the cutting plate.
9 Switch off and unplug.
hints
Use fresh ingredients.
G
Don't cut food up too small. Fill the
G
width of the large feed tube fairly full.
This prevents the food from slipping
sideways during processing.
Alternatively, use the small feed tube.
When using a chipper plate, place
G
thin ingredients horizontally.
When slicing or shredding: food
G
placed upright comes out shorter
than food placed horizontally.
After using a cutting plate there will
G
always be a small amount of waste
on the plate or in the food.
cleaning
Always switch off and unplug before
G
removing the attachment from the
kitchen machine.
Dismantle the attachment fully before
G
cleaning.
Never immerse the connector in
G
water, wipe over with a damp cloth.
Wash remaining parts in hot soapy
G
water, then dry thoroughly. Take care
as the blades and cutting plates are
sharp. Alternatively wash in the
dishwasher (top rack only).
service and customer
care
If the cord is damaged it must, for
G
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
UK
If you need help with:
using your appliance
G
servicing or repairs (in or out of
G
guarantee)
call Kenwood customer care on
023 9239 2333.
spares and attachments
G
call 0870 2413653.
other countries
Contact the shop where you bought
G
your appliance.
Designed and engineered by
G
Kenwood in the UK.
Made in China.
G
5