Creating Profiles; Standby Setup - Leister VARIANT T1 Instructions D'utilisation

2. Profile Setup

2.2 Creating Profiles

6
• The Profile Setup allows you to create 3 individual profiles for
which the name, and all three parameters Drive
Blower can be freely set and then saved by pressing the
62
e-Drive (Fig. 21).
• The various menu items can be selected using the controls (4). Pres-
1
sing the e-Drive
• If the ABC
e-Drive
by pressing the e-Drive
• In the Profile Name menu, you can turn the e-Drive
the characters _ / . / A to Z / 0 to 9, as well as the left or
right arrows and the symbols Save
• Change profile name
– If you turn the e-Drive
If the right arrow is selected by pressing the e-Drive
position in the profile name will jump one character (black) to the
right. If you activate the left arrow by pressing the e-Drive
position in the profile name will jump one character (black) to
the left (Fig 23).
– Turning the e-Drive
If you press the e-Drive
the character previous selected.
• Save or reject profile name
– If the Save
by pressing the e-Drive
– If the Back
(not saved) by pressing the e-Drive
Carry out a test weld according to the welding instructions of the material manufacturer and
national standards or directives. Check test weld.

2.3 Standby Setup

• The standby times defines the time that has to pass (no buttons pressed, welding
nozzle (9) not in welding position) before the cooling process (see Section 1.8
Cooling) is automatically triggered.
• Turning the e-Drive
set at the factory.
• Pressing the e-Drive
38
will take you back to the Profile Setup selection.
%
symbol is activated by turning the
, you will be taken back to the menu Profile Name
(Fig. 22).
you can select the left or right arrows.
allows the required character ( _ / . / A to Z / 0 to 9) to be selected.
the character shown black in the profile name will now be replaced by
symbol is selected by turning the e-Drive
Save
.
symbol is selected by turning the e-Drive
allows the time to be set from 5 to 120 minutes. 40 minutes are
will take you back to the Profile Setup selection.
, Heating
to select
or Back
Save
, the
.
1
,
2
3
(Fig. 21)
.
, the
, the profile name will be saved
, the profile name will be rejected
6
62
1
%
(Fig. 22)
1
G J K
S T
U X Y Z
2 3 4 5 6 7 89
Save
(Fig. 23)