Choosing A Battery Charger; Preparing The Battery Charger; Squeegee Adjustment - Dustbane Hurricane Rally Manuel D'opération

Choosing a battery charger

Make sure the battery charger is compatible with the batteries to be charged. Tubular lead batteries: an automatic charger is
recommended. Consult the battery charger manufacturer and manual to confirm the choice. Gel batteries: use a charger specific
for this type of battery.
DANGER:
Use CE-marked battery chargers that comply with the relevant product standards (EN60335-2-29), featuring double or
reinforced insulation between input and output, and a SELV output circuit.

Preparing the battery charger

If you wish to use a battery charger not provided with the machine, you must fit it with the connector supplied with the machine.
The connector supplied for the external battery charger is suitable for cables with a minimum crosssection of 16 mm2. Proceed as
follows to fit the connector: Remove about 13 mm of protective sheath from the red and black cables of the battery charger. Insert
the wires into the connector contacts and squeeze them forcefully with suitable pliers. Respect the polarity (red wire + black wire –)
when inserting the wires into the connector.
Squeegee Installation and Adjustments
Switch the machine on, lower the squeegee by pressing the suction motor button. Place the squeegee in the slots
provided on the support (fig. 4), then tighten the fastening knobs and insert the suction hose.

Squeegee adjustment

The squeegee blades scrape the film of water and detergent from the floor and prepare the way for perfect drying. With time, the
constant rubbing makes the edge of the blade in contact with the floor rounded and cracked, reducing the drying efficiency and
requiring it to be replaced. The state of wear should be checked frequently.
For perfect drying, the squeegee must be adjusted in such a way that the edge of the rear blade bends during operation by about
45° with respect to the floor at every point. The angle of the blades can be adjusted using the screw (fig. 5, ref. 1), while the height
of the squeegee from the floor can be adjusted by changing the height of the two wheels (fig. 6).
5