Emptying The Collection Tank - Dustbane Hurricane Rally Manuel D'opération

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Working
Sit correctly in the seat.
Turn the main switch to position "1".
Select the direction of travel with the direction selector.
Select the AUTO or ECO program.
Press the accelerator pedal to move off and start work.
Some useful tips to get the most from your scrubber drier
In the event of particularly stubborn dirt on the floor, washing and drying can be performed in two separate operations. Prewashing
with brushes or pads:
Turn the main switch to position "1".
Select the AUTO or ECO program.
Press the suction motor button to stop suction.
Press the accelerator pedal to move off and start work.
If necessary, adjust the flow of detergent delivered to the brush, using the water/detergent button; the outlet flow
must be metered in relation to the required travel speed; the slower the machine travels, the less detergent must be
delivered.
Persist when washing particularly dirty points to give the detergent time to perform its chemical action detaching and
suspending the dirt and the brushes time to exert an effective mechanical action.
Drying:
Lower the squeegee and with the suction motor on, pass over the same area washed previously. The result is equivalent to in-depth
washing and subsequent ordinary maintenance will take less time.

Emptying the collection tank:

If the tank is full, the display shows the corresponding alarm, see "Display
alarms"; after a few seconds, the suction motor shuts down, then stop
the machine and empty the tank following the instructions shown below:
Switch off all the machine's functions.
Take the machine to the disposal area.
Unhook the hose from the clip.
Empty the tank using the hose (see figure), at the end rinse
the tank with clean water.
Emptying the water/detergent tank
To empty the tank, follow the instructions shown below:
Switch off all the machine's functions.
Take the machine to the disposal area.
Stop the machine.
Empty the tank by unscrewing the plug (see figure below).
9

Publicité

Table des Matières
loading

Table des Matières