Fuses: Replacing - Dustbane Hurricane Rally Manuel D'opération

Cleaning the dirty water tank float
Open the dirty water tank lid, clean the float (figure below) situated at the front of the dirty water tank, making sure not to aim the
water directly against the float; make sure it slides freely on its rod.

Fuses: replacing

DANGER!
This operation must be performed with the machine switched off and the key removed. Never usea fuse with a higher
amperage than specified. Do not rest the electronic board panel on the batteries, as a short-circuit may cause the
batteries to explode.
If a fuse continues to blow, the fault in the wiring, boards (if present) or motors must be identified and repaired. Have the machine
checked by qualified personnel. Lift the dirty water tank, disconnect the battery wiring connector from the electrical system (fig.20.
ref. 1-2-3), lift the electronic boa rd panel, secure it to the corner of the tank, as shown in the figure (figure 21), then check the fuses.
12