Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
"ONBOARD" battery charger:
•
Lift the dirty water tank
•
Unplug the battery charger.
•
Plug the cable into the power socket (fig. 25).
•
Start the recharge cycle.
•
The display will show when the recharge cycle ends, see "Display alarms"
•
At end of the recharge cycle, unplug the cable from the power socket.
Replacing the squeegee blades
•
Switch the machine on, lower the squeegee by pressing the suction
motor button.
•
Remove the suction hose from the squeegee (fig. 26).
•
Unscrew the fastening knobs.
•
Remove the squeegee from the slots on the support.
•
Open the hook (fig. 27, ref. 1).
•
Push the two blade pressing devices (fig. 27, ref. 2) outwards, then
remove them.
•
Remove the blade.
•
Reuse the same blade by reversing the edge in contact with the floor
until all four edgesare worn out, or replace with a new blade, fitting it
onto the screws on the body of the squeegee.
•
Reposition the two blade pressing devices by centering the wider part
of the slots on the squeegee body fastening pins, then push the blade
pressing devices inwards.
•
Close the hook again.
•
Replace the squeegee on its support, following the instructions
described previously.
Pushing and pulling the machine:
•
When the electric drive cannot be used, the machine can be easily pushed
or pulled by turning the lever (fig. 28) clockwise, so as to release the electric
brake. After moving the machine, set the lever back to the original position.
WARNING!
If the lever is in the position where the electric brake is disengaged (lever turned clockwise), the machine's brake
will be disabled. Never start the machine with the electric brake disabled.
14
Publicité
Table des Matières
