Novoferm NovoSpeed Retail Manuel D'application page 9

4.13a
GB
4.13b
Attach the wiring of the drive, and the pulse generator with the metal mounting brackets
as indicated. Make sure that the door panel cannot chafe the cables.
14
When using the plug-in drive: attach the top roller
with the 3 supplied M12 bolts.
Then remove the packaging from the top roller.
4.14a
When using the bolt-on drive: slide the block bearing over
the shaft and attach it to the console with 2 supplied M12
bolts. Then remove the packaging from the top roller.
4.14b
key
Secure the drive support to the console with 2 M10 bolts. Place the key in the
key bed and slide the drive onto to the shaft. Add a drop of oil to make it easier
to slide. Tighten the drive to the drive support with two M8 bolts.
drive support
GB
15