Cleaning And Troubleshooting Your Waterpik - Waterpik CC-01 Mode D'emploi

10

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

WATER FLOSSER
®
Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit to prevent
clogging by partially filling reservoir with warm water and running unit with
ON
tip pointed into sink until unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product
when necessary by using a soft cloth and mild non-abrasive cleanser.
The water reservoir is removable for easy cleaning and is top rack
dishwasher safe.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral
content of your water. If left unattended, it can hinder performance. Cleaning
internal parts: add 2 tablespoons of white vinegar to a full reservoir of warm
water. Point the handle and tip into sink. Turn unit ON and run until reservoir
is empty. Rinse by repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal
performance.
Leakage
If leaking due to a damaged hose, replacement hoses and handles can be
purchased at www.waterpik.com or contact Water Pik Inc. customer service
for a self service repair kit.
Service Maintenance
Waterpik Water Flossers have no consumer serviceable electrical items and
®
do not require routine service maintenance. For all accessories go to
www.waterpik.com. You may also call our toll-free customer service number at
1-800-525-2774 (USA) or 1-888-226-3042 (Canada). Refer to the serial and
model numbers in all correspondence. These numbers are located on the
bottom of your unit.
Still have questions? Go to www.waterpik.com.