Cleaning And Troubleshooting Your Waterpik; Water Flosser - Waterpik WP-950 Mode D'emploi

8

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

Orthodontic Tip
To use the orthodontic
tip, gently glide tip along
gumline, pausing briefly
to lightly brush area
between teeth and all around orthodontic bracket,
before proceeding to the next tooth.
Plaque Seeker
®
To use the Plaque
Seeker tip, place
®
the tip close to the
teeth so that the
bristles are gently touching the teeth. Gently glide
tip along gumline, pausing briefly between teeth to
gently brush and allow the water to flow between
the teeth.
Using Mouthwash and Other Solutions
Your Waterpik Water
®
Flosser can be used to
deliver mouthwash and
antibacterial solutions. After
using any special solution,
rinse unit to prevent clogging
by partially filling reservoir
with warm water and running
unit with tip pointed into sink
until unit is empty.
Tip
Cleaning
Before cleaning, unplug from the electrical outlet.
Clean the product when necessary by using a soft
cloth and mild non-abrasive cleanser.
The accessory storage container and the water
reservoir are removable for easy cleaning and are
top rack dishwasher safe.
Removing Hard Water Deposits
Hard water deposits may build up in your unit,
depending on the mineral content of your water.
If left unattended, it can hinder performance.
Cleaning internal parts: add 2 tablespoons of white
vinegar to a full reservoir of warm water. Point the
handle and tip into sink. Turn unit ON and run until
reservoir is empty. Rinse by repeating with a full
reservoir of clean warm water.
This process should be done every 1 to 3 months
to ensure optimal performance.
Leakage
If leaking due to a damaged hose, replacement
hoses and handles can be purchased from your
local distributor, which can be found at
www.waterpik.com/intl.

WATER FLOSSER

®