Cleaning And Troubleshooting Your Waterpik; Water Flosser - Waterpik WP-60 Mode D'emploi

8

CLEANING AND TROUBLESHOOTING YOUR WATERPIK

a 45-degree angle and gently place the tip under
the gumline, into the pocket. Turn the unit on and
continue tracing along the gumline.
Tongue Cleaner Tip
To use the tongue cleaner tip, set to lowest pressure
setting, place tip in the center/middle of your tongue
about half way back and start the Water Flosser. Pull
forward with light pressure. Increase pressure as you prefer.
Using Mouthwash and Other Solutions
Your Waterpik ® Water Flosser can be used to deliver mouthwash and
antibacterial solutions. After using any special solution, rinse unit to prevent
clogging by partially filling reservoir with warm water and running unit with
tip pointed into sink until unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product when
necessary by using a soft cloth and mild non-abrasive cleanser.

WATER FLOSSER

®
The water reservoir is removable for easy cleaning and is top rack
dishwasher safe.
NOTE: Remove reservoir valve before placing
reservoir in dishwasher.
Removing Hard Water Deposits
Add 2 tablespoons of white vinegar to a full reservoir of warm water. Set
pressure control dial to high, point the handle and tip into sink. Turn unit
ON (I) and run until reservoir is empty. Rinse by repeating with a full
reservoir of clean warm water.
Leakage
If leaking due to a damaged hose, replacement hoses and handles can be
purchased from your local distributor, which can be found at
www.waterpik.com/intl.
If leakage occurs from the reservoir, ensure the valve is right
side up or contact your local distributor for a replacement valve.
Remove Replace