Waterpik WP-60 Mode D'emploi page 7

Prime Unit (First Time Use Only)
Set pressure control dial on base to
high, point the handle and tip into
sink. Turn unit ON (I) until water
flows from the tip. Turn unit OFF (O).
Adjusting the Pressure Setting
Slide the pressure control switch located on
the handle to the lowest setting (away from the
tip as far as possible) for first-time use. Gradually
increase pressure over time to the setting you prefer
– or as instructed by your dental professional.
Recommended Technique
For best results, start with the back teeth and work toward the
front teeth. Glide tip along gumline and pause briefly between teeth. Continue
until you have cleaned the inside and outside of both the upper and lower teeth.
Lean over sink. Direct the stream at a 90-degree
angle to your gumline with tip in mouth.
High
Slightly close lips to avoid splashing, but allow water to flow freely from
mouth. Set pressure at desired setting and turn the unit ON (l). Begin cleaning.
Pause Control
You can temporarily stop the flow any time by
pressing the pause button on the handle.
When Finished
Turn the unit OFF (O). Empty any liquid left in the reservoir.
Unplug the unit.
NOTE: If you used a mouthwash or other solution besides water, see "Using
Mouthwash or Other Solutions" section.
1 1
TIP USAGE
Pik Pocket ® Tip
The Pik Pocket tip is specifically designed to deliver water
® 2 2
or anti-bacterial solutions deep into periodontal pockets.
To use the Pik Pocket tip, set the unit to the lowest
®
pressure setting. Place the soft tip against a tooth at
7
Pause
Button