Miele MF03 10 Notice De Montage page 16

Produktgruppe 512
16 von 60
Connection for water recycling - PW 610x, PW 613x, PW 616x, PW 620x
Disconnect the machine from the electric mains supply provided in accordance with all relevant regulations and ensure utilities
cannot be switched on again in error. Carry out a check to ensure that no power is supplied to the machine.
Remove the screws on the left and right of the top of the lid.
Lift the front of the lid slightly, slide it to the rear and thus release the centring cones at the rear of the lid from the connection strip.
Remove the lid upwards.
Remove the rear panel.
Remove the mixer box cover plate on the rear of the machine, Fig. 1.
Loosen the hose clip on the drain hose and disconnect the hose, Fig. 2.
Drill out the water recycling intake on the mixer box to a diameter of approx. 28 mm, Fig. 4.
Warning!
Take care to collect and remove the drilling swarf at the mixer box drain outlet, Fig. 2.
Fit the water intake hose with hose clip on the mixer box connection stub and tighten the hose clip, Fig. 6.
Fit the mixer box cover plate with the throughfeed for the intake flange, Fig. 7.
Refit the mixer box drain hose on the mixer box drain outlet and tighten the hose clip.
Connection for water recycling - PW 6241, PW 6321
Disconnect the machine from the electric mains supply provided in accordance with all relevant regulations and ensure utilities
cannot be switched on again in error. Carry out a check to ensure that no power is supplied to the machine.
Remove the machine lid.
Remove the rear panel.
Remove the mixer box cover plate on the rear of the machine.
Pre-assemble the suds container / connection strip connection hose, Fig. 8.
Note
For the PW 6321 the hose must be shortened such that the dimension X1 = 80 mm.
The hose to the connection strip must be shortened such that the dimension X2 = 28.5 mm, Fig. 8.
Remove the blinding stopper on the suds container.
To secure the holder, Fig. 8, Pos. 1, drill a 6 mm hole in the suds container. Distance from rolled seam X = 110 mm, Fig. 9.
Lay the connection hose in the machine, Fig. 10.
Fit the angled connector and holder on the suds container, Fig. 11.
Pass the cover plate through the opening in the connection strip and fit it.
Fasten the connection hose with cable ties to the water intake hoses, Fig. 12.
Connection for water recycling - WS 5101, WS 5141, WS 5191, WS 5240, WS 5320
Disconnect the machine from the electric mains supply provided in accordance with all relevant regulations and ensure utilities
cannot be switched on again in error. Carry out a check to ensure that no power is supplied to the machine.
Remove the machine lid.
Remove the rear panel.
Remove the mixer box cover plate on the rear of the machine.
16.12.2011 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 04598534