A20 Alarm Reset Procedure; Ventilation System Test; Information And Technical Service - Icar RPC 8BGA Manuel Complet

ICAR PQS
Repeat the same operation for the four clips.
Tighten the fixing screw with a maximum torque of 0,5Nm.
In case it is necessary to dismount the system, repeat the steps in opposite order.
For the electrical connection, see the wiring diagrams in the dedicated chapter and the requirements reported in the technical
characteristics table.

27 A20 ALARM RESET PROCEDURE

From the main page press one time the ▲button to access at the
page "SERVICE":
Press and hold the ◄ button until the hours of maintenance will
not return to be 9000.

28 VENTILATION SYSTEM TEST

From the main page, press three times the ▼button to access at
the page TEMPERATURE:
From the page TEMPERATURE press and hold the ◄
the indication
"FAN STATUS" changes from "OFF" to "ON".
After 30 seconds the ventilation system will stop.

29 INFORMATION AND TECHNICAL SERVICE

Please contact:
by ORTEA S.p.A. Via dei Chiosi 21 20873 Cavenago B.za (MB) – Italia
button until
ICAR Power Quality Solutions
Tel. +39 02 9591 7800
tech.cv@icar.com
50 / 86
rev9 jan19