Nilfisk Advance SC901 ST Serie Mode D'emploi page 10

A - ENGLISH
BATTERIES (CONTINUED)
1 Remove the batteries from their shipping crate and carefully inspect them for cracks or other damage. If damage is evident, contact the
carrier that delivered them or the battery manufacturer to fi le a damage claim.
2 Turn the Master Key Switch (A) OFF and remove the key.
3 Tip the recovery tank to the side, locked position. Remove the battery cables from inside the battery compartment.
4 Your machine comes from the factory with enough battery cables to install six 6 volt batteries. Carefully lift the batteries into the battery
compartment and arrange them exactly as shown in Figure 1. Secure the batteries as close to the back of the machine as possible.
NOTE: Battery spacers (O) need to be installed between the bottom of the batteries and the short wall on the bottom of the tank to create
more space between the batteries and prevent the Deck Lever Arm (P) from hitting the batteries.
5 Install the battery cables as shown. Position the cables so the battery caps can be easily removed for battery service. To prevent
interference, route the cable (Q) over the top of the Deck Lever Arm (P) as shown in Figure 1.
IMPORTANT!: The protective caps supplied with the batteries need to be left on or re-used to completely cover the
portion of the battery terminals that are not being protected by the battery cable terminal cover boots supplied with the
battery cables. This also applies to the inline fuse holder boot.
6 Carefully tighten the nut in each battery terminal until the terminal will not turn. Do not over-tighten the terminals, or they will be very diffi cult
to remove for future service.
7 Coat the terminals with spray-on battery terminal coating (available at most auto parts stores).
8 Put one of the rubber terminal cover boots over each of the terminals and connect the Battery Pack Connector (15).
9 Make sure the Fuse Holder Boot (R) is covering the fuse holder, the cable end of the Battery Pack Connector (15), and as much of the battery
terminal as possible. Leave the protective caps supplied with the batteries in place or re-use to cover the terminal areas not protected by the
terminal cover boots.
FIGURE 1
O
A - 10
INSTRUCTIONS FOR USE
310AH @ 20HR RATE
BATTERY SPACER
BATTERY SPACER
Q
SC901 ST - 56091217
P
15
R
3/2019