Troubleshooting - Ego Power+ ST1530 Guide D'utilisation

TROUBLESHOOTING

PROBLEM
String trimmer fails
to start.
String trimmer
stops while cutting.
32
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC
CAUSE
◾
The battery pack is not
attached to the trimmer.
◾
No electrical contact
between the trimmer and
the battery pack.
◾
The battery pack is
depleted.
◾
The lock-off button and
switch trigger are not
depressed simultaneously.
◾
The guard is not mounted
on the trimmer, resulting in
an overly long cutting line
and motor overload.
◾
Incorrect cutting line is
used.
◾
The motor shaft or trimmer
head is bound with grass.
◾
The motor is overloaded.
◾
The battery pack or string
trimmer is too hot.
◾
The battery pack is
disconnected from the tool.
◾
The battery pack is depleted.
SOLUTION
◾
Attach the battery pack to the
trimmer.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Press down on the lock-off button
and hold it, then depress the switch
trigger to turn on the string trimmer.
◾
Remove the battery pack and mount
the guard on the trimmer.
◾
Use recommended nylon cutting line
with diameter no greater than
0.095 in. (2.4 mm).
◾
Stop the trimmer, remove the
battery, and remove the grass from
the motor shaft and trimmer head.
◾
Remove the trimmer head from the
grass. The motor will recover to work
when the load is removed. When
cutting, move the trimmer head in
and out of the grass to be cut and
remove no more than 8 inches of
length in a single cut.
◾
Allow the battery pack or trimmer
to cool until the temperature drops
below 152°F (67°C).
◾
Re-install the battery pack.
◾
Charge the battery pack.