Ego Power+ ST1530 Guide D'utilisation page 23

4. Cut one piece of cutting line 16ft.
(5 m) long. Insert the line into the
mounting hole located inside the
eyelet. Push the line until the end of
the line comes out of the other side
of the spool base. Pull the line from
the other side until equal amounts
of line appear on both sides of the
spool (Fig. 13).
5. Press, while rotating the spool
retainer in the direction indicated by
the arrow, to wind the cutting line
onto the spool until approximately
5.5in. (14 cm) of line is showing on
each side (Fig. 14).
6. Push the spool retainer down while
pulling on the lines to manually
advance the line and to check for
proper assembly of the trimmer
head.
If the cutting line breaks from the line
outlet or the cutting line is not released
when the trimmer head is tapped, follow
the steps below:
1. Remove the battery pack.
2. Press the two release tabs on the
spool retainer and remove the spool
retainer by pulling it straight out
(Figs. 15 & 16).
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC
13
14
15
Release Tab
16
Spool Retainer
Mounting Hole
inside the Eyelet
5.5" (14 cm)
Spool Base
23