Ego Power+ ST1530 Guide D'utilisation page 16

3. Attach the front-assist handle and
lower clamp onto the shaft and
secure them by pre-tightening the
four screws. TURN THE FRONT-
ASSIST HANDLE UPWARDS SO THAT
IT POINTS TOWARDS THE TOP OF
THE REAR HANDLE (Fig. 5).
4. Adjust the front-assist handle
position between the rear handle
housing and warning label on the
shaft, as shown in Fig. 5. The handle should be adjusted so your front arm will be
straight when using the trimmer.
5. Tighten the four screws so that the handle cannot be rotated on the shaft.
16
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC
5
Warning
Label
Rear Handle
Housing