Mounting The Guard - Ego Power+ ST1530 Guide D'utilisation

MOUNTING THE GUARD

WARNING:
when mounting or replacing the guard.
Be careful of the blade on the guard and
protect your hands from being injured by
the blade.
1. Loosen the two bolts in the guard
with the supplied hex wrench;
remove the bolts and spring
washers from the guard (Fig. 2).
2. Lift the trimmer head and face it
downward; align the two mounting
holes in the guard with the two
assembly holes in the base of the
shaft. Make sure that the internal
surface of the guard faces towards
the trimmer head (Fig. 3).
3. Use the supplied hex wrench to lock
the guard in place with the bolts.
MOUNTING AND ADJUSTING THE
FRONT- ASSIST HANDLE
1. Remove the battery pack from the
trimmer.
2. Loosen the four screws in the
handle with the supplied hex
wrench and remove the screws and
the lower clamp from the front-
assist handle (Fig. 4).
56-VOLT LITHIUM-ION CORDLESS 15" BRUSHLESS STRING TRIMMER — ST1530/ST1530-FC
Always wear gloves
2
3
4
Screws
Lower Clamp
Front-Assist Handle
15