Mounting The Guard - Ego Power+ PH1400 Guide D'utilisation

MOUNTING THE GUARD

WARNING:
the cultivator attachment is connected to
the power head.
1. Loosen and remove the bolt from
the guard with the supplied hex
wrench (Fig. 2).
2. Lift the cultivator attachment shaft
and remove the end cap from the
shaft.
3. With the slot in the guard aligned
with the rib on the end of the shaft,
pass the guard through the shaft
until the screw holes in the guard
and in the shaft are aligned
(Fig. 3 & 4).
4. Use the supplied hex wrench to
tighten the bolt clockwise to lock
the guard securely.
16
CULTIVATOR ATTACHMENT — CTA9500/CTA9500-FC
Install the guard before
2
3
Rib
4
Bolt
Slot