Storing The Unit; Cleaning The Unit - Ego Power+ RTX2300 Mode D'emploi

3. Before installing new blades, put the shaft cup on the
shaft (Fig. D3). Put the top-blade with big hexagonal
hole onto the shaft with the surface printed "EGO"
logo facing toward the gear case (Fig. D4), then put
the bottom-blade with small hexagonal hole onto
the shaft with the surface printed EGO" logo facing
toward operator (Fig. D5).
NOTICE: Make sure the hexagon holes on the blades
and hexagon shaft shoulder fit in place. Otherwise
once the blades are mounted reversely, the ROTOCUT
cannot work correctly and will damage the blades.
4. Follow the sequence shown in Fig. D1 to reassemble
them.
LUBRICATE THE GEAR CASING
For best operation and longer lifetime, lubricate the
gear case with a special grease (4-5g each time) after
every 50 hours operation.
The special grease should meet the following
requirements.
1. Belong to DIN51818: NLGI-1 cone penetration degree.
2. Ester base grease.
3. Excellent low-temperature startup, EP, mechanical
shearing, abrasion resistance and oxidative stability
properties.
4. Operation temperature must contain -40~180°C.
Remove the sealing screw. Fill grease into the gear
case through the oil-hole.
WARNING: Do not lubricate while the tool is still
connected with battery or running.

CLEANING THE UNIT

◾
Clean the unit using a damp cloth with a mild
detergent.
◾
Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by
certain aromatic oils, such as pine and lemon, and
by solvents such as kerosene. Moisture can also
cause a shock hazard. Wipe off any moisture with a
soft dry cloth.

STORING THE UNIT

◾
Disconnect the battery power from the tool when it
is not in use.
◾
Clean the tool thoroughly before storing it.
◾
Store the unit in a dry, well-ventilated area, locked-
up or up high, out of the reach of children. Do not
store the unit on or adjacent to fertilizers, petrol, or
other chemicals.
◾
Use of a transport cover for metal blades during
transport and storage.
Protecting the environment
WEEE (Waste Electrical and Electronic
Equipment)
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric tools must be returned
to an environmentally compatible recycling
facility.
ROTOCUT — RTX2300
EN
9