Troubleshooting - Ego Power+ ST1510T Manuel De L'opérateur

TROUBLESHOOTING

PROBLEM
String trimmer fails
to start.
String trimmer
stops while cutting.
28
56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1510/ST1510-FC
CAUSE
◾
The battery pack is not
attached to the trimmer.
◾
No electrical contact
between the trimmer and
the battery pack.
◾
The battery pack is
depleted.
◾
The lock off trigger is not
being moved forward
before depressing the
switch trigger.
◾
The guard is not mounted
on the trimmer, resulting in
an overly long cutting line
and motor overload.
◾
Heavy cutting line is used.
◾
The motor shaft or trimmer
head is bound with grass.
◾
The motor is overloaded.
◾
The battery pack or string
trimmer is too hot.
◾
The battery pack is
disconnected from the tool.
◾
The battery pack is depleted.
◾
Unbalanced after
installation of cutting line.
SOLUTION
◾
Attach the battery pack to the
trimmer.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Move the lock-off trigger forward
and then press the switch trigger.
◾
Remove the battery pack and mount
the guard on the trimmer.
◾
Use recommended nylon cutting
line with diameter no greater than
0.095in. (2.4 mm).
◾
Stop the trimmer, remove the
battery, and remove the grass from
the motor shaft and trimmer head.
◾
Remove the trimmer head from the
grass. The motor will recover to work
as soon as the load is removed.
When cutting, move the trimmer
head in and out of the grass to be
cut and remove no more than 8
inches of length in a single cut.
◾
Cool the battery or string trimmer.
◾
Re-install the battery pack.
◾
Charge the battery pack.
◾
Tap the trimmer head to make the
rope length symmetrical.