Ego Power+ ST1510T Manuel De L'opérateur page 17

ADJUSTING THE TRIMMER
HEIGHT
If the length of the shaft is not suitable for
operation, you can adjust the length of the
shaft with the height-locking clamp.
1. Remove the battery pack from the
trimmer.
2. To adjust the trimmer height, open
the height-locking clamp, and then
slide the shaft up or down to desired length, securing it in place by depressing the
height-locking clamp. (Fig.11.)
NOTICE: The loop handle may require to be readjusted after the trimmer height is
changed.
56-VOLT LITHIUM-ION CORDLESS BRUSHLESS STRING TRIMMER — ST1510/ST1510-FC
11
Height-Locking Clamp
17