Troubleshooting - Ego Power+ HTX6500 Guide D'utilisation

TROUBLESHOOTING

PROBLEM CAUSE
◾
◾
◾
◾
◾
Hedge trimmer
dose not work.
◾
◾
The power cord from the
battery is not attached to the
hedge trimmer correctly.
No electrical contact between
the hedge trimmer and power
cord.
The EGO portable battery
pack or the EGO backpack
battery is depleted.
The lock-off switch is not
placed to the "ON" position
before starting.
The two switch levers on
the front handle and rear
handle are not pressed
simultaneously.
The battery or the hedge
trimmer is too hot.
The blade is jammed.
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HTX6500
SOLUTION
◾
Reinsert the power cord plug, ensuring
that the GREEN seal on the plug is
COMPLETELY disappearing into the
socket.
◾
Check all the contacts and reconnect
the hedge trimmer with the power
cord.
◾
Depending on battery type, choose
appropriate charger to charge the
battery.
◾
Before starting, make sure that the lock-
off switch is placed to the "ON" position.
◾
Press the front switch lever and rear
switch lever simultaneously after
adjusting the lock-off switch to the
"ON" position.
◾
Disconnect the battery from the
hedge trimmer and allow the battery
or the hedge trimmer to cool until
its temperature drops below 152°F
(67°C).
◾
Disconnect the power cord from the
hedge trimmer . Wear gloves to remove
the obstruction carefully and check
the blade. If no damage or bend of the
blade, reconnect with the power cord
to start the hedge trimmer.
27