Dualit 3en 1 Manuel D'utilisation Et Garantie page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IB-DCM2X-US-A.2_Layout 1 03/04/2014 10:45 Page 16
CLEANINg - MONTHLY
BEFORE CLEANINg, ENsURE THE MACHINE Is sWITCHED OFF, UNPLUggED AND
ALLOWED TO COOL. UsE EsE PODs TO REDUCE FREqUENCY OF CLEANINg.
1
2
WIPE BREWHEAD
Wipe the entire brewhead
Using a screwdriver and
area and ensure it is
hammer, gently tap the screw
completely free of coffee
to dislodge any dried coffee.
grounds. Fine coffee grounds
Then unscrew anti-clockwise
can block the showerhead.
to remove the showerhead
and gasket ONLY.
4
5
UNBLOCk FILTER
Filters often get blocked with
Locate the measuring spoon
prolonged use. To unblock,
onto the steam wand nut.
use the pin supplied and
Unscrew anti-clockwise and
push through the central
remove.
hole on both sides of the
filter to unblock.
3
UNsCREW
CLEAN BREWHEAD
Thoroughly clean the
showerhead and gasket to
remove any coffee grounds.
Use the filter pin to unblock
or rinse in suds.
6
UNsCREW
CLEAN THE
sTEAM WAND
Use the steam pin to remove
dried milk from inside the
steam wand. Use the
measuring spoon to place the
nut back on the steam wand.
screw clockwise until tight.
16
7
fLUSH THE
8
REPLACEmENT
STEAm wAND
STEAm wAND
AVAILAbLE
ImPORTANT NOTICE:
If steps 5-7 are unsuccessful,
Turn on your machine. Flush
please contact Electra-Craft
the steam wand by
on (201) 439-1700 or email
dispensing water or steam to
info@electra-craft.com for a
remove any milk residue
replaceable steam wand.
from inside the steam wand.
9
fILTER PAPER
Remember to use filter
papers. These can help to
prevent filter blockages.
17

Publicité

Table des Matières
loading

Table des Matières