Dispensing Hot Water; Cleaning - After Each Use - Dualit 3en 1 Manuel D'utilisation Et Garantie

IB-DCM2X-US-A.2_Layout 1 03/04/2014 10:45 Page 14

DIsPENsINg HOT WATER

CAUTION: WATER WILL BE HOT AND BE DIsPENsED AT HIgH PREssURE.
sUBMERgE THE WAND TO REDUCE sPLAsHINg.
1 2
PREPARE
Remove the froth nozzle
set the steam/water
from the steam wand.
selector switch to the water
Caution: Wand may be hot. setting.
Ensure the water tank is
filled with water.
4
5
INsERT WAND
Insert into a deep jug or Turn the control knob to
teapot and point the wand the steam/water position to
to a side wall to reduce start the water flowing. You
splashback. will hear the pump; this is
quite normal.
3
WAIT 40 sECONDs
sELECT WATER
Wait for the temperature
indicator to go out.
6
sTART DIsPENsINg sTOP DIsPENsINg
To stop the flow, turn the
control knob to the 'off'
position. The machine will
purge to get ready for the
next coffee.
14

CLEANINg - AFTER EACH UsE

BEFORE CLEANINg, MAkE sURE THE MACHINE Is sWITCHED OFF, UNPLUggED
AND ALLOWED TO COOL.
Do not wash any of the plastic accessories or filter holder in a dishwasher.
2
1
THE FILTERs
DRIP TRAY
Turn the filter holder upside Empty the drip tray regularly.
BIN
If the red tray full indicator is
down over a bin and knock
out the grounds. Be careful visible, empty immediately.
not to throw away the cup Remove the non-slip mat and
filter. rinse after each use.
4
5
fLUSH THE
WIPE THE WAND
STEAm wAND
After each use, clean the ImPORTANT NOTICE:
wand with a damp cloth. After each use, flush the
steam wand by dispensing
There should be no milk
residue visible. water or steam, this will
remove any milk residue
from inside the steam wand.
3
THE NOzzLE
Pull the froth nozzle off the
wand and wash under
running water to remove
any milk residue.
6
EMPTY WATER
TANk
Empty and rinse out after
each session and refill with
fresh water just before you
make your next round of
espresso.